A transport layer protocol usually has several responsibilities. One is to create a process-to-processcommunication UDP uses（1）numbers to accomplish this. Another responsibility is to provide controlmechanisms at the transport level, UDP does this task at a very minimal level. There is no flow control mechanismand there is no（2）for received packet. UDP, however, does provide error control to some extent. If UDPdetects an error in the received packet, it will silently drop it.

The transport layer also provides a connection mechanism for the processes. The （3）must be able to sendstreams of data to the transport layer. It is the responsibility of the transport layer at （4） station to make theconnection with the receiver chop the stream into transportable units, number them, and send them one by one. Itis the responsibility of the transport layer at the receiving end to wait until all the different units belonging to thesame process have arrived, check and pass those that are （5）free, and deliver them to the receiving process asa stream.

（1）是（）

A.hop

B.port

C.route

D.packet

张拉千斤顶在整拉整放工艺和单拉整放工艺中，单束初调及张拉宜采用（）千斤顶。整体张拉和整体放张宜采用（）千斤顶，张拉吨位宜为张拉力的1.5倍，且不得小于1.2倍，张拉千斤顶在张拉前必须经过校正，校正系数不得大于1.05。校正有效期为一个月且不超过200次张拉作业，拆修更换配件的张拉千斤顶必须重新校正。